six to eight day beak trimming. eighteen week old pullet trimmed with this method

19
Six to Eight Day Beak Trimming

Upload: clifton-harmon

Post on 18-Dec-2015

216 views

Category:

Documents


0 download

TRANSCRIPT

Page 1: Six to Eight Day Beak Trimming. Eighteen Week Old Pullet Trimmed With This Method

Six to Eight Day Beak Trimming

Page 2: Six to Eight Day Beak Trimming. Eighteen Week Old Pullet Trimmed With This Method

Eighteen Week Old Pullet Trimmed With This Method

Page 3: Six to Eight Day Beak Trimming. Eighteen Week Old Pullet Trimmed With This Method

Guide Plate Used for Beak Trimming

Hole sizes 11/64, 10/64 and 9/64 inches. Select best size hole for the beak size. Slightly more than half of the beak should extend through the hole.

Page 4: Six to Eight Day Beak Trimming. Eighteen Week Old Pullet Trimmed With This Method

Motorized CamForeground

• Motor controlled cam

• Cam operates on 1500 cycle/hour

• Blade down time is just over 2 seconds

Page 5: Six to Eight Day Beak Trimming. Eighteen Week Old Pullet Trimmed With This Method

Cam Position

Position of cam on beak trimmer. The brown bar on the bottom is the touch switch to activate the cam.

Page 6: Six to Eight Day Beak Trimming. Eighteen Week Old Pullet Trimmed With This Method

Trimming Position

Forefinger is held under the throat to apply a slight pressure back and downward to hold the tongue back.

Page 7: Six to Eight Day Beak Trimming. Eighteen Week Old Pullet Trimmed With This Method

Positioning Chick For Trimming

The thumb must apply a gentle but firm pressure on the back of the head to hold the beak in the guide plate.

Page 8: Six to Eight Day Beak Trimming. Eighteen Week Old Pullet Trimmed With This Method

Trimming Position

Insert beak into the hole with a gentle pressure holding tongue back with index finger.

Page 9: Six to Eight Day Beak Trimming. Eighteen Week Old Pullet Trimmed With This Method

Trimming Chick

Chick in left hand will be trimmed next. Left hand steadies right hand during trimming. Touch plate below chick starts trimming cycle.

Page 10: Six to Eight Day Beak Trimming. Eighteen Week Old Pullet Trimmed With This Method

Trimming A Chick

This machine is equipped with a foot control switch preferred by some trimmers. Note angle of head during trimming.

Page 11: Six to Eight Day Beak Trimming. Eighteen Week Old Pullet Trimmed With This Method

Chick After Trimming

Page 12: Six to Eight Day Beak Trimming. Eighteen Week Old Pullet Trimmed With This Method

Catching Chicks

Net used to catch chicks from a floor pen. Chicks must be handled gently to avoid injury.

Page 13: Six to Eight Day Beak Trimming. Eighteen Week Old Pullet Trimmed With This Method

Brooder Ring Divided By A Catching Frame For Gentle

Catching

Page 14: Six to Eight Day Beak Trimming. Eighteen Week Old Pullet Trimmed With This Method

Catching & Positioning Chicks

Catcher gently drops chicks into a box positioned at a comfortable height for the trimmer at right. Box has raised wire sides to prevent chick escape.

Page 15: Six to Eight Day Beak Trimming. Eighteen Week Old Pullet Trimmed With This Method

Dropping Chicks

Chicks are dropped onto a box covered with soft excelsior pads to prevent injury.

Page 16: Six to Eight Day Beak Trimming. Eighteen Week Old Pullet Trimmed With This Method

Trimmer at Work

One catcher can usually supply chicks for up to four trimmers. This trimmer is using a foot controlled switch.

Page 17: Six to Eight Day Beak Trimming. Eighteen Week Old Pullet Trimmed With This Method

Crew of Three Workers Can Trim 11,000 Chicks in this

House in Nine Hours

Page 18: Six to Eight Day Beak Trimming. Eighteen Week Old Pullet Trimmed With This Method

Six to Eight Day Beak Trimming

Cauterizing blade should be cherry red during trimming to prevent re-growth of beak

Page 19: Six to Eight Day Beak Trimming. Eighteen Week Old Pullet Trimmed With This Method

This Powerpoint Presentation was produced by Ralph Ernst, Extension Poultry

Specialist, Department of Animal Science, University of California Using Slides from a

UC Cooperative Extension Slide Set Authored by Ervin Bramhall, Farm Advisor,

Retired.