smartphone holder xl - accentuate€¦ · c d e a g b h i assembly instructions hl6500 smartphone...
TRANSCRIPT
C
D
E
A
G
B
H
I
Assembly instructions HL6500
SmartphoneHolder XL
x1 — Phone Holder
x1 — Bungee
x1 — Handlebar ClampBolt
x2 — Rubber Shim
x1 — Thumb Screw
x1 — Stem Mount
x1 — Short Bolt
x1 — Dry Bag
x4 — Phone Bumpers
Parts
A
B
C
D
E
F
G
HH
I
Tool RequiredPhillips HeadScrewdriver
WARNINGUsing phone device while riding can cause accidents resulting in serious injury.Important: Nuts and bolts can loosen over time, resulting in serious danger should the item fall o� while in motion.Check frequently to ensure all bolts are properly tightened. Ensure the device �ts snugly in the holder before riding.Not for o�-road use.
STEM MOUNT OPTIONHANDLEBAR CLIP OPTION
F
STEM BOLT
1
1
2
2
1
1
2
2
Delta Cycle Corporation 36 York Avenue, Randolph, MA 02368 USA / 800-474-6615 / www.designbydelta.com
Need help?Email us at [email protected]& we’ll help solve your issue.
Assembly videoVisit designbydelta.com/downloads
Using the Handlebar Clamp
Using the Stem Mount
IMPORTANTSAFETY NOTEDo not attach clampto any tapered sectionof your handlebar.
IMPORTANTSAFETY NOTE
Connect holder to handlebar clampusing short bolt and adjust angle beforefull tightening.
Connect handlebar clamp to barusing rubber shims as needed. Use thumb screw; tighten tosecure the handlebar clamp.
Remove existing stem cap from bicycle.Use existing stem bolt to install Smartphone Holder stem mount on to your bicycle stem.
Connect holder to stem mountusing short bolt and adjust anglebefore full tightening.
Never loosen thestem clamp bolts.