30-BRAKE ZIP LINE BRAKING SYSTEM INSTALLATION MANUAL

Thank you for purchasing our new braking system.

AdventureParks.com 520 Salem Avenue

Holly Springs, MS 38635 800.848.8688

Note: This braking system works on cables up to 3/16”. If you are installing your new compression spring braking system at the same time as installing a ZLX, ZL90 or ZL70, the installation of the braking system will be directly after threading the trolley on the cable in step 6 and for ZL35 it is step 4. If your ZLX, ZL90, ZL70 or ZL35 is already installed, then disassemble your zip line at the low end or stopping end of your zip line, install your compression spring braking system, then reinstall your cable. Zip Line Fun installation manuals can be found online at http://www.ziplinefun.com/installation-manuals/ INSTALLATION INSTRUCTIONS:

Step 1: Step 2: Step 3: Continue your zip line installation per the installation manual.

Insert the cable through the brake stop that is inserted on the spring and feed all the through until the cable is sticking out of the other end of the spring.

PARTS LIST:

1. 4.5 foot compression

spring

2. Two brake stops

Thread the cable through

the second brake stop

and then push the brake

stop onto the spring until

it is on completely.