updating 400p
DESCRIPTION
TRANSCRIPT
As you are aware of by now Bartec has released software
Revision 39!
This tutorial will show you how to update your tool to the latest and greatest software Bartec has to
offer
First make sure yourTool is powered offAnd NOT plugged
Into your PC
Go to our website at www.bartecusa.com and click the
log in tab as shown below.
Log into your account using your user name and
password
Click on the tool management button
Locate the tool you are trying to update by serial number and click the
download button for that tool
When this window appears click the save button
At this screen click save…DO NOT CLICK OPEN here
Once you have saved your file you can close or minimize
your web browser and your file will appear on your
desktop
Now you want to put your tool in program mode by pressing and holding the enter button and pressing the
green power button at the same time
Your tool screen should read NO UPDATE FILES
FOUND
Insert the USB cord into your PC then insert the other end into your tool…The USB port for your tool is located on the
right side
This removable disk screen should pop up on your computer screen containing a file labeled
PROG.BIN
If the removable disk window doesn’t launch click on the start key at the bottom of the screen and open the
removable disk located under the devices with removable storage tab
Click and drag or copy and paste the update file into the removable
disk window
Once you move the update file to the window it will automatically begin to download the program to your tool
Within seconds your computer will show it is downloading the file to your tool…this process will take around ten seconds to complete
During this process your tool screen will read NO UPDATE
FILES FOUND
Once the downloading process is complete remove the USB cord from the tool and press the test button located in the
middle of the tool
Your tool will read VERIFYING FILE
Your tool will then say VERIFY
COMPLETE ERASING
PROGRAM
Your tool will then begin programming and show
you the status
This process will take about thirty
seconds
When your tool is done programming it will shut
itself off
Power your tool back on by pressing the green power key and under the Bartec logo it should say the new
software level is 39