ANTI HIJACK

ANTI HIJACK

46 Central convenience

10 - AdaptationChannel 03 Auto Lock (auto locks car after 10mph)Channel 04 Auto Unlock (unlock the car when u take the key out)Lock / unlock beeps

46 Central convenience

10 - Adaption

Channel 05 Unlock, horn sounds (not a horn, more like a beep when u unlock)Channel 06 Lock, horn sounds (same as above only other way around)Channel 07 Unlock, turn signals flash (easy)Channel 08 Lock, turn signals flash (easy)

SINGLE DOOR UNLOCK46 Cent Convenience07 - Recode

The single door unlock give an even number i.e 00064. To make all the doors unlock with one press, just add 1 i.e. 00065 Recode for warning lamps:

17 - Instruments07 - Recode

Look at the first two digits in the coding. Add the values for the options together to get the correct coding.

00 - No available equipment+01 - Brakepad wear sensor warning active+02 - Seatbelt warning active+04 - Washer fluid level warning active

Look at the third digit in the coding (Market version):1 - "EU" 24 hour clock & L/100km fuel consumption and KM odometer

2 "USA" 12 hour clock & Mpg (US gallon)3 - "Canada" 12 hour clock (may result in odometer in km in 2002+ clusters):As USA4 - "UK" 24 hour clock & Mpg (Imperial gallon)

5 Japan - ?6 - Saudi Arabia - ?7 Australia - ?)

Headlamp Adjustment:

[Select][55 - H. Light Range][Basic Settings - 04]Set channel to "000"[Do It!]Wait about 20 secondsManually adjust headlamps[Done, Go Back]

CHANGING LANGUAGE SETTINGS17 - Instruments 10 - AdaptationChannel 4: the number is your language

1: German2: English3: French4: Italian5: Spanish6: Portuguese7: Czech

Idle Speed Adaptation (may not work with APH engines, see your Repair Manual):With engine warmed up, at idle:01 engine

10 Adaptation

Enter channel 01 (Channel 02 for TDI engines)Enter an adaptation value between 124 and 132[Save]

Throttle Body Alignment:

Turn the key on but do not start the car.

01 - Engine][Measuring Blocks - 08]Group 060 (may be Group 098 on cable-throttle cars)[Go!][Switch to basic settings]

Once you do this you will see the top right display say ADP RUN. The TB adaptation is being done as soon as you switch to basic settings. You will see the values change and hear the TB cycle for the first few seconds then it will stop. Leave it in Basic Settings for about 30 seconds, then press the [Switch to measuring blocks] button and you're all set.

Be sure not to touch the accelerator and make sure the engine is NOT running when you do this!

Activating Cruise Control Factory fresh ECU's often come with cruise control de-activated. If this is the case, there will not a letter "G" in the Component field of VAG-COM when connected to the Engine.

[Select][01 - Engine][Login - 11]Enter 11463 to activate cruise control[Do It!]

After doing this procedure, there should be a letter "G" in the Component field.

Steering44 steering assist07 - recodeSoft coding = 011x0 or 012x0

Replace x with a number from 1 9

2 = GTI

3 = Comfort

6 = Handicapped (very light)