Vietnam Training Agenda

Introduction to DataLink Plus and DataVision

Installation of DataLink Plus

Installation of DataVision

Installation of Vietnam Bitmaps

DataLink Plus

Configuration of Outstations and System Exercise 1 Retrieval of Data from Vision meter Exercise 2 Viewing of Data Exercise 3 Exporting of Data Exercise 4 Load Profile Viewer Exercise 5

DataVision

Creation of Maps Exercise 1 Charts and Chart Templates Exercise 2 Reports and Report Templates Exercise 3 Tariffs Exercise 4 Automatic production of Charts & Reports – Queues Exercise 5

Installation of DataLink and DataVision

1. DataLink Plus

Insert disk marked DataLink Plus into computer disk drive Select the ‘Start’ button followed by the Run option Type in the path A:\Install, select the OK button

Select the option Full Installation of Application, select the OK button

Enter the source disk drive as A:\, select the OK button Enter the destination disk drive as C:\, select the OK button

The DataLink Plus software will now be installed into the C:\ABB\CS directory.

2. DataVision

Insert disk marked DataVison – Disk 1 into computer disk drive

Select the ‘Start’ button followed by the Run option Type in the path A:\Setup, select the OK button

The following box will then appear

Enter Disk 2, select the OK button. The following box will then appear

Select the OK button. The following screen will then appear

Select the button pointed to by the arrow i.e. installation button

The software will then installed into the C:\ABB\DVISION directory

Note : - For the remaining disks follow the instructions on the screen i.e. enter relevant disk, select the OK button.

3. Installation of Bitmaps

Insert disk marked Vietnam Bitmaps into computer disk drive.

Using Windows Explorer or Windows File Manager copy all bitmaps from the floppy disk A:\ into the directory C:\ABB\D_VISION\BITMAPS.