· web viewdate 27/9 vibration table. motor coupled date 27/9 vibration table. motor coupled and...

6
Date 27/9 vibration table. Motor coupled

Upload: others

Post on 05-Apr-2020

2 views

Category:

Documents


0 download

TRANSCRIPT

Page 1:  · Web viewDate 27/9 vibration table. Motor coupled Date 27/9 vibration table. Motor coupled and after greasing reduced for awhile Date 4/10/15. G’s increase back Date 4/10. Fan

Date 27/9 vibration table. Motor coupled

Date 27/9 vibration table. Motor coupled and after greasing reduced for awhile

Page 2:  · Web viewDate 27/9 vibration table. Motor coupled Date 27/9 vibration table. Motor coupled and after greasing reduced for awhile Date 4/10/15. G’s increase back Date 4/10. Fan

Date 4/10/15. G’s increase back

Date 4/10. Fan side increase then g’s increase to red.

Page 3:  · Web viewDate 27/9 vibration table. Motor coupled Date 27/9 vibration table. Motor coupled and after greasing reduced for awhile Date 4/10/15. G’s increase back Date 4/10. Fan

Date 13/10/15. Fan side rising

Date 11/11/15. Solo run with high g’s. Recommended to grease

Page 4:  · Web viewDate 27/9 vibration table. Motor coupled Date 27/9 vibration table. Motor coupled and after greasing reduced for awhile Date 4/10/15. G’s increase back Date 4/10. Fan

Date 11/11/15 evening. G’s reduced to normal

Date 12/11/15 early morning 2.22hrs G’s raised back to alarm

Page 5:  · Web viewDate 27/9 vibration table. Motor coupled Date 27/9 vibration table. Motor coupled and after greasing reduced for awhile Date 4/10/15. G’s increase back Date 4/10. Fan

Date 8/1/16: Swap with FD Fan unit 1A after new installed new bearings, new shield and rotor

Date 8/1/16: After EM greasing

Page 6:  · Web viewDate 27/9 vibration table. Motor coupled Date 27/9 vibration table. Motor coupled and after greasing reduced for awhile Date 4/10/15. G’s increase back Date 4/10. Fan

Date: 9/1/16: EM suddenly show high 1x rotational speed vibration – unbalance force on motor higher than fan side.

Date 11/1/16: Could be motor solo run and values are OK.