pallet box light

A stylish box made from two used shipping pallets which can serve as a lighting arrangement. This can be used indoors or outdoors.

The light and shadow effect created due to the slits between the pallets is poetic!

Pallet Box Light

Instructables by Biji-biji Initiative

Materials Tools

• Pallet – One set• Plywood• Screws• Marker / Chalk• Tape measure• Safety gear

• Jigsaw• Driller ( screw drill bit)

Materials and Tools Checklist:

Pallet Box LightInstructables by Biji-biji Initiative

• Mark a line in the middle of each pallet dividing it into two equal parts.

• Two pallets of the same size are required for this project.

Pallet Box LightSTEP 1 Instructables by Biji-biji

Initiative

• Use a jigsaw to cut on the centre line.• You will get two parts as shown.

• Place these parts upright as shown.

• Repeat this procedure for the other pallet and so you will have four parts.

Pallet Box LightInstructables by Biji-biji Initiative STEP 2

• Fix the parts together by using screws and power drill.

• Repeat the procedure to combine other parts till the four sides are done.

• Use screws at the top and bottom on each side.

Pallet Box LightSTEP 3 Instructables by Biji-biji

Initiative

This is how the box will look.

• Using a tape measure , check the size of the square and cut two pieces of plywood in the same size.

• Using screws fix one plywood piece to the box.• This will be the base. • So invert the box.

Measure these sides

Pallet Box LightSTEP 4 Instructables by Biji-biji

Initiative

• Using just one screw , fix the other plywood piece on one corner.

• This will be the lid which can be twisted to open and close.

The pallet box light is now ready. Ole..

• The electric light can be fixed inside.

screw

Pallet Box LightSTEP 5 Instructables by Biji-biji

Initiative