dMT – SPC Metallschutzprodukte auf Trockenbasis

dMT-SPC dry protective coatings contain a mixture of special components (no graphite) which create and continually maintain an optimal coefficient of friction between two surfaces

dMT – SPC Surface Protective Coatings

 

dMT - Surface Protective Coatings System for Support Trunnions and Ringson Kilns, Rotating Furnaces, Dryers, Mills, etc.

Rotating Drum Equipment

This picture shows a example of a SPC DRR-5.0L Block System with 5 spring-loaded, steel applicators. The number of required blocks / applicators or size of the unit depends upon the width of the trunnions or rings to be coated.

 Type TSB-085-DRR Blocks are used on supporting trunnions without a drive function. SPC blocks are to be inserted from the rear side of each applicator.

Example: Block System with 5 Steel Applicators

 

SPC-TRB-100 blocks with steel applicators mounted against tyre surface

SPC-Coatings for trunnions and tyres of rotating furnaces, kilns, dryers

(noticable „mirror image“ on surface)

Rotating Drum Equipment

Rotating Drum Equipment

 SPC-Coatings for trunnions and tyres of rotating dryer

 

 SPC-Coatings for trunnions and tyres on asphalt dryer with chain drive

June 2002 – installation of 2 sets of SPC DRR-T-2.0 kits each with 2 TRB-100-DRR blocks to reduce wear on rollers and tyre. Maintenance-free operation of kits.

Rotating Drum Equipment

 

 

SPC-TRB-100 low c.o.f. blockwith stainless-steel applicator type KR-RB-160

 Rotating incinerator for hazardous waste at a chemicals production plant

SPC-Coatings for trunnions and tyres, as well as thrust rollers, on rotating furnace

Rotating Drum Equipment

DRR-T-4.0 low c.o.f. block-Kit