floor tiling made easy with entice construction

125, Platinum Plaza, Opp. IOC Petrol Pump Judges Bungalow Road, Bodakdev, Gujarat-380054 +91-079-40056230 [email protected]://www.enticeworld.in

Floor tiling does not have to be difficult so here are some easy steps to follow:The first thing you must ensure is that the surface is completely flat. If you have removed the old tiles all of the cement should be removed. Because a tile is not flexible it cannot accommodate even the slightest hump or bump. Take note that it is not advisable to tile on top of a wooden floor. By their very nature floorboards tend to move as weight is applied, which means that every time you step on it the boards beneath the tiles will move, which will in turn will cause the tiles to shift and it is highly likely that over time they will [email protected] http://www.enticeworld.in+91-079-40056230

Floor tiling does not have to be difficult so here are some easy steps to follow:Next mark the centre point of each wall approximately 1 inch above floor level. At these marks tap in a small nail and tie two chalk line tightly between the Nails on opposite walls. Snap the chalk lines by pulling them upwards one at a time and letting them go. They should snap against the floor and leave at chalk impression on the floor. This should leave you with a chalk intersection in the middle of the floor, this point where the two lines cross is the centre point of your floor. This is where your tiling will [email protected] http://www.enticeworld.in+91-079-40056230

Floor tiling does not have to be difficult so here are some easy steps to follow:It is now a good idea to lay out your tiles loosely and decide carefully what pattern you want to follow, after all you will be looking at this handiwork for a long time to [email protected] http://www.enticeworld.in+91-079-40056230

Floor tiling does not have to be difficult so here are some easy steps to follow:When you have decided what pattern to follow, begin at the centre point and apply your adhesive. You will laying tiles in opposite directions from each other so if you can imagine yourself in the middle of the floor you will lay one at your right hand, and then one at your left hand and so on until you reach the wall on your right and the wall on your left. Only apply enough adhesive to lay about four or six tiles at a time. As you are just learning how to tile, floor tiling can be time-consuming and my advice is not to use a quick setting adhesive as it sometimes does not allow you much time to fix mistakes. Make sure to use tile spacers at the corner of each tile, as this will keep each tile the same distance [email protected] http://www.enticeworld.in+91-079-40056230

Floor tiling does not have to be difficult so here are some easy steps to follow:When you reach the walls it is likely that you will need to cut tiles. Carefully measure the depth of cut you require and mark the tile with a sharpie. Place the tile in your tile cutter and mark the tile with the blade. Snap the tile gently and it should easily break. When you have cut your tile place the cut side of the tile against the wall leaving the finished side [email protected] http://www.enticeworld.in+91-079-40056230

Floor tiling does not have to be difficult so here are some easy steps to follow:Continue with this process until your floor is complete. Do not underestimate the importance of finding the exact centre. Just to be sure you have definitely got it right, measure it twice. Get this wrong and everything else will also be [email protected] http://www.enticeworld.in+91-079-40056230

Floor tiling does not have to be difficult so here are some easy steps to follow:When your tiles have set you will now be in a position to apply your grout. Mix your grout according to the instructions on the packet and apply with a floating sponge taking care to ensure that every joint is filled. After about 45 minutes begin to wipe the tiles in a circular motion to remove excess grout. It is likely that you will need to do this several times. When you're happy with your grout leave it to set for at least 24 [email protected] http://www.enticeworld.in+91-079-40056230

USE RHINO BONDER FOR BETTER FLOOR [email protected] http://www.enticeworld.in+91-079-40056230

[email protected] http://[email protected] | +91-079-40056230http://www.enticeworld.in