front bumper removal installation
DESCRIPTION
Manual taller como Montar/Desmontar defensa delantera MAZDA2 DETRANSCRIPT
FRONT BUMPER REMOVAL/INSTALLATIONid091000405100
1. Disconnect the negative battery cable. (Vehicles with front fog lights)2. Remove screw A and screws B, and set the
mudguard out of the way in the direction of the arrowshown in the figure.
SCREW A
MUDGUARD
SCREW B
am2zzw00001602
3. Remove screws C.
SCREW C FRONT
FRONT BUMPER
am2zzw00003465
4. Remove the fastener D. FASTENER D
RADIATOR GRILLE
am2zzw00001604
5. Remove the bolts from position (1) indicated in the figure, pull the front bumper in the direction of arrow (2) shownin the figure to disengage the both ends from the front bumper slider, then remove the front bumper in the directionof arrow (3).
TAB
FRONT BUMPER
FRONT BUMPER SLIDER
TAB
FRONT BUMPER
FRONT BUMPER SLIDER
(1) (1)
(2)(2)
(3)
BOLT BOLT (2)
BOLT:6.9—9.8 N·m{71—99 kgf·cm,62—86 in·lbf}
am2zzw00001787
Caution• The front bumper and front bumper slider are engaged firmly. If they are disengaged forcibly the
bumper could fall and be damaged. Perform the servicing carefully when disengaging the frontbumper from the front bumper slider.
• When disengaging the front bumper from the front bumper slider, the front bumper could fall andbe damaged. Support the front bumper so that it does not fall.
6. Disconnect the front fog light connector. (Vehicles with front fog lights)7. Install in the reverse order of removal.8. Adjust the front fog light aiming for vehicles with front fog lights. (See FRONT FOG LIGHT AIMING)
Front Bumper Installation Note1. Spread the front bumper ends apart.2. Assemble the front bumper to the body.3. Press the front bumper connecting area in the
direction of the arrow shown in the figure to engagewith the front bumper slider.
FRONT BUMPER SLIDER
FRONT BUMPER
am2zzw00001606