machine design i (mce-c 203) - fayoumfayoum.edu.eg/stfsys/stffiles//243//2378//07) machine... ·...
TRANSCRIPT
Machine Design I(MCE-C 203)
1
Mechatronics Dept.,
Faculty of Engineering,
Fayoum University
Dr. Ahmed Salah Abou Taleb
Lecturer, Mechanical Engineering Dept.,
Faculty of Engineering, Fayoum University
Course OutlinesDesign of detachable joints: ( threaded joints , keys and splines).
2
Keys Pins. Splines.
Introduction
3
How attach power transmission components to shaft to prevent rotation and axial motion?
Torque resistance: keys, splines, pins, weld, press fit, etc..
Axial positioning: retaining rings, locking collars, shoulders machined into shaft, etc….
Keys
4
• A key is the piece inserted in an axial direction between a shaft and hub of the mounted machine element such as pulley or gear etc., to prevent relative rotation….
• Keys are temporary fastening and are always made of mild steel because they are subjected to shearing and compressive stresses caused by the torque they transmit.
• a keyway is the groove cut in the shaft or hub to accommodate a key.
Keys
5
Keys Design
6
• keys are sunk in the shaft and the hub.
Let D = diameter of the shaft
- width of the key W = D/4
Rectangular cross-section
nominal thickness H = (2/3)W = (1/6)D
Square cross-section:
nominal thickness H = W = D/4
Keys Design
7
Step 1 – Determine key size based on shaft diameter.
Step 2 – Calculate required length, L, based on torque.
Shear stress
Bearing stress
Required Length based on Shear Stress:
NSywhereDW
TL d
d
/5.02
Required Length based on Bearing Stress:
NSywhereDH
TL d
d
/4
N = 3
T = F*(D/2) or F = T/(D/2) this is the force the key must react!!!
Keys Design
8
Keys Design
9
Splines
10
“Axial keys” machined into a shaft
Transmit torque from shaft to another machine element
Advantages:
•Can carry higher torque for given diameter (vs keys).
•Lower stress on attachment (gear)
•Better fit, less vibration (spline integral to shaft so no vibrating)
•May allow axial motion while reacting torque
Disadvantage:
•Cost
•Impractical to use as fuse
Splines Design
11
Torque capacity is based bearing stress on the sides of the splines
T = 1000*N*R*h
N = number of splines
R = mean radius of the splines
h = depth of the splines )dD(2
1h
4
dD
2
dD
2
1R
8
dDN1000
2
dD
4
dDN1000T
22
Splines Design
12
A: Permanent Fit
B: Slide without Load
C: Slide under Load
Splines Design
13
T = kD2L
T = torque capacity
kD2 = torque capacity per unit length (from Table 11-5)
L = length of spline in inches
Splines Design
14
Splines Design
15