remanufactured = precision 5-14news... · 2014. 12. 19. · there’s a lot more than a fine line...

1
There’s a lot more than a fine line between a rebuilt Carlyle and a Genuine Carlyle Remanufactured Compressor. SALES CENTERS Remanufactured = Precision Remanufactured = Precision A Genuine Carlyle Remanufactured Compressor hasn’t just been taken apart, cleaned up, and put back together. It’s been completely stripped down and precisely remanufactured - to the point where it’s nearly impossible to tell it apart from a brand new compressor. © Carrier Corporation 5/2012 Factory Authorized Parts for Carrier ® , Bryant ® or Payne ® equipment can only be found at your Totaline Sales Centers. For the location nearest you visit www.totaline.com • All electrical components have been upgraded to Carlyle’s latest design standards meeting the requirements for UL recognition. • Any machined component that is 5/10,000 of an inch off spec is scrapped and replaced. • All critical wearing parts are brand new. • All parts have been gauged, bored, honed, ground, polished, tested, or replaced as needed. • It’s a Factory Authorized Part * *

Upload: others

Post on 31-Jan-2021

3 views

Category:

Documents


0 download

TRANSCRIPT

  • There’s a lot more than a fine line between a rebuilt Carlyle and a Genuine Carlyle Remanufactured Compressor.

    SALES CENTERS

    Remanufactured = Precision

    Remanufactured = Precision

    A Genuine Carlyle Remanufactured Compressor hasn’t just been taken apart, cleaned up, and put back together.

    It’s been completely stripped down and precisely remanufactured - to the point where it’s nearly impossible to tell

    it apart from a brand new compressor.

    © Carrier Corporation 5/2012

    Factory Authorized Parts for Carrier®,Bryant® or Payne® equipment can only befound at your Totaline Sales Centers.

    For the location nearest you visit www.totaline.com

    • All electrical components have been upgraded to Carlyle’s latest design standards

    meeting the requirements for UL recognition.

    • Any machined component that is 5/10,000 of an inch off spec is scrapped and replaced.

    • All critical wearing parts are brand new.

    • All parts have been gauged, bored, honed, ground, polished, tested, or replaced as needed.

    • It’s a Factory Authorized Part

    *

    *