how to make tesselation/pop up
TRANSCRIPT
HOW TO MAKE A TESSELLATION
STEP 1
Firstly, construct a one parallelogram
STEP 2
Then, construct another parallelogram beside the first one.
STEP 3
After that, construct the third parallelogram and place it above other two parallelograms.
STEP 4
Then, copy the image that has been constructed and combine them both.
STEP 5
After that, fill the image with any color .
To color the image, firstly, we have to highlight the points of the area
needed. Then, select ‘interior’ in the ‘display’ section. After that, color it
with any color.
STEP 6
Then, copy the image produced and palace it under the first one.
THE TESSELLATION PRODUCED
HOW TO MAKE A POP-UP
Pop-up’s name : Providence
STEP 1
Cut out the card following the solid, GREY lines around the edges only. Color in
the picture of Topo with markers or crayons, but make sure you DON’T color in
the areas that say “Glue Here!”
STEP 2
Fold the card in half, closing it along the center fold line you've just scored.
Crease it with your thumb and finger, then open the card up again.
STEP 3
Cut out Providence and the flying machine carefully following the solid, GREY
lines around the edges. DO NOT cut any of the black lines!
STEP 4
Fold the entire pop-up piece in half along the center fold line, making sure that all
the dotted lines are still visible
STEP 5
Open the pop-up piece again and lay it on a flat surface. Take hold of the lower
LEFT wing of the flying machine
STEP 6
and fold it up, creasing the fold with your thumb or finger. Lower the piece back
down to it’s original position again.Repeat this with the lower RIGHT wing of the
flying machine.
STEP 7
Make hold of the lower part of the LEFT wing as shown above and SLOWLY
begin to push the wing, along it's fold, over to the right.
STEP 8
Continue pushing until the wing lays completely over to the RIGHT side as
shown above. Open the wing back up and repeat this process the wind on the
other side.
STEP 9
Providence and the flying machine should now look like this! The wings on either
side should be coming in slightly towards the center.
STEP 10
Take hold of the upper part of the LEFT wing and fold it towards the back,
making sure that all the dotted lines are still visible. Take hold of Providence
between your thumb and finger and begin pinching her
STEP 11
Providence and the flying machine should look like this! Providence should be
leaning forward, the upper part of the wings should be leaning back and the side
wings should be coming in slightly towards the center.
STEP 12
Take the Topo card and apply glue only to the areas indicated. Make sure you
apply glue near the insides of the GREY lines!
STEP 13
Place the lower parts of the wings over the glue areas on the card
STEP 14
Carefully press down letting the glue dry.
STEP 15
The pop-up is complete.